Recent content by sparkymarka

Post picture of handset and front panel …chances of getting a replacement switch is probably zero …

That’s comm 3 when you use the adaptor …

What firmware is the panel ? Menu 4 from unset You may have to use com 2 for gsm and use the com 3 for ip instead

A check detector lid ( either it’s broke or just needs putting back on correctly ) Open panel lid and leave it open it won’t reset …it won’t activate again

With skill ….

Use com port + adaptor that plugs on the digi port

As above ….how long as it been fitted ?

You have set chime to all devices ….follow user guide to turn off

You need to search by …..glass fuse … as below

Not sure ….you need a 1amp quick blow fuse

Blown the keypad fuse ? Normally on the left near the keypad connections ?

Change it to timed and see what happens

A piece of alarm cable ….unless you have an R8 plus with resistors

What arming type are you using ? Final door set ….or ….. timed ? As the pir may still be active when you close the door if using final door set

Wire the keypad via a piece of cable direct onto the panel ….